Filter
Top Products
ENGLISHENGLISHENGLISHENGLISHENGLISHENGLISH
RQTX1207
9
99
Using the radio
Manual tuning
1
Press [SOURCE] to select “RADIO FM” or “RADIO AM”.
2
Press [2/–, ADJ] or [+/6, ADJ] to select the desired
frequency.
To tune automatically
Press and hold [2/–, ADJ] or [+/6, ADJ] until the frequency
starts changing rapidly. Automatic tuning stops when it fi nds a
station or when [2/–, ADJ] or [+/6, ADJ] is pressed again.
Note:
For better reception, extend and change the direction of the FM
or AM antenna.
Memory preset
You may store your favourite channels in 5 FM or 5 AM preset
channels.
Preparation
Press [SOURCE] to select “RADIO FM” or “RADIO AM”.
Automatic presetting (AP)
Press and hold [SOURCE] until “AP” is displayed.
Note:
• Automatic presetting begins from the current frequency.
• Only the fi rst 5 stations detected will be stored.
• “AP” will blink continuously until all 5 channels have been set.
Manual presetting
1
Press [2/–, ADJ] or [+/6, ADJ] to select the desired
frequency.
2
Press and hold [SET/PRESET] for 2 seconds to display
the preset number.
3
Press [2/–, ADJ] or [+/6, ADJ] to select a preset
number.
4
Press [SET/PRESET] again to confi rm.
Tuning in to a preset channel
Press [SET/PRESET] to switch between preset channels.
FM or AM allocation setting
This system can also receive FM broadcasts allocated in
0.1 MHz steps or AM broadcasts allocatd in 9 kHz steps.
1
Press [SOURCE] to select “RADIO FM” or “RADIO AM”.
2
Press and hold [4/9].
After a few seconds the display changes to a fl ashing
display of the current minimum frequency. Release the
button when the minimum frequency changes.
• To return to the original step, repeat the above steps.
• After changing the setting, previously preset frequency will
be cleared.
Using the sleep timer
This function enables you to turn off the unit automatically after
the set time (only in iPod and radio mode).
1
Press [SLEEP] to activate the timer.
2
Press [SLEEP] again to select your desired time
(in minutes).
OFF (default)
]
30
]
60
]
90
]
120
Note:
Press [SLEEP] once to check the remaining time.
RQTX1207-Y_1us.indd 9RQTX1207-Y_1us.indd 9 6/21/2010 9:10:44 AM6/21/2010 9:10:44 AM