Filter
Top Products
7
Listening to the Radio
The letters such as A in the various illustrations refer to the descriptions in the “Location of Controls” section (See page 4.) .
When using overseas (Except for United Kingdom)
(Available only from the main unit)
Change the frequency step according to the area.
Preparation: Press [RADIO/BAND] to switch on the power.
1 Press for more than 5 seconds to display the step.
2 Within 10 seconds
Press to select the step.
AM 9 (original setting) : AM 9 kHz
AM 10 : AM 10 kHz
3 Within 10 seconds
Press and hold until the frequency is displayed to con-
firm the step.
∫ To return to the previous frequency step
Repeat the above procedure.
Note!
Converting the allocation erases the stations previously stored in memory.
Changing the sound quality
The operation is the same as when playing CDs.
(See page 4.)
To obtain good reception
AM
Try various directions to obtain optimum reception.
Note!
The AM antenna is located in the rear of the unit so noise may increase if the unit is
held. This is not a malfunction.
FM
The earphone cord is also the FM antenna, so extend it rather than leaving it coiled.
∫ How to receive an FM broadcast clearly
(Available only from the main unit)
Press for more than 1.5 seconds during FM reception.
Leave off under normal conditions. Set to “CITY” if reception is poor or if there is in-
terference from another station.
To select stereo or monaural FM
(Available only from the main unit)
Press during FM reception.
∫ When there is noise during FM reception
Select “MONO”.
Sound becomes monaural, but noise is reduced.
S
EC
ON
DS
E
A.SHOCK
FM RECEPT
%CITY/NOR
“CITY” (----. “ ” (normal)
“MONO” (----. “ ” (stereo)
FM
CITY
TUNED
C
REPEAT
FM MODE
MONO/ST
FM
MONO
TUNED
I
R
A
D
I
O
/
B
A
N
D
A
TUNING
9
:
MEMORY/
RECALL
B
Each time the button is pressed:
AM
Each time the button is pressed:
Each time the button is pressed
AM 9 ,# AM 10
^ -----------------J