Filter
Top Products
9
RQT5210
Listening
2
3
4
1
42 31
L
A
FM AM
1
3
2
MEMORY/
PGM
1
2
3
Indicates auto scan
Listening to radio broadcasts
Listening to broadcast stations which have
not been programmed (Manual tuning)
Preparation: Set [ ] to “TUNER”.
1
Press [BAND] to select “FM” or “AM”.
Every time you press the button: FM ↔ AM
2
Press [TUNE MODE] to clear the preset indicator.
The unit is set to the manual tuning mode.
3
Press [–/g] or [f/+] to tune in the station.
4
Adjust the volume.
RX-D11 only
When using the remote control
1. Press [BAND] to select “FM” or “AM”.
2. Press [–/g] or [f/+] to tune in the station.
Automatic tuning:
This is a simple way of tuning in stations that have not been preset.
Keep [–/g] or [f/
+] depressed, and release it when the frequency
display starts to change. A station with good reception is automatically
selected and the selection process then stops.
To stop automatic tuning, press [–/
gg
gg
g] or [
ff
ff
f/+]
again.
Hint
Automatic tuning may stop without a station having been tuned in
when interference is encountered on neighbouring airwaves. In such
a case, tune in a station by tapping [–/
gg
gg
g] or [
ff
ff
f/+].
Using auto scan
RX-D11 only
You can search for a station by listening to all tuned-in stations for 8
seconds each.
Preparation: Set [ ] to “TUNER”.
(Only from the remote control)
Press [BAND] to select “FM” or “AM”.
Press [AUTO SCAN].
Auto scan starts.
Press [AUTO SCAN] when you find the desired
station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To turn off the unit:
Set [ ] to “TAPE/ ”.
If the tape is travelling, press [L/c STOP/EJECT] as well.
Adjusting the antennas A
For FM reception:
Pull out the telescopic antenna and adjust its length and angle for
optimum reception.
For AM reception:
Turn the unit in the direction which gives the best results.
Reference
Radio broadcasts may be hard to receive in a moving vehicle or in a
building because the signal may be weakened. In such cases, use the
unit near a window.
When there is a lot of noise in an FM stereo
broadcast
Reduce the interference by setting the sound to monaural.
Example:
When an FM stereo program is being received;
Press [FM MODE].
“
MONO
” is displayed.
To return to stereo reception, repeat the same procedure to turn off
the “
MONO
” display.