Filter
Top Products
30
Installation (continued)
CQ-5800U
Mounting and removing the Main Unit
Method for Fixing the Rear of the Unit
❏ Mounting Procedures (When using Mounting Collar w)
Note:
¡The car model, installation conditions and combination
of the units used may impose some restrictions on oper-
ating position.
IMPORTANT
When this unit is installed in dashboard, ensure that there
is sufficient air flow around the unit to prevent damage
from overheating. Do not block any ventilation holes on the
unit.
q
w
e
r
t
Insert the Mounting Collar w into the dash-
board, and bend the mounting tabs out with a
screwdriver.
Establish the rear connection of the unit.
After fixing Power Connector, fix the rear of the
unit to the car body by either method (a) or (b).
Insert the unit into Mounting Collar w.
Secure the clamp plate of Mounting Collar w to
the hook.
Insert Trim Plate q.
After installation reconnect the negative (–)
battery terminal.
Snapping point
q
w
e
t
r
Fire Wall of Vehicle
tHex. Bolt
(5 mmø x 25 mm)
oToothed Lock Washer
yHex. Nut (5 mmø)
yHex. Nut
iSpring Washer
iSpring Washer
uPlain Washer
uPlain Washer
eRear Support Strap
Mounting Bolt (5 mmø)
wMounting Collar
Mounting bolt
(5 mmø)
w Mounting collar
Rear support bracket
(provided on the vehicle)
Rubber cushion (option)
(a) Using the rear support strap e
(b) Using the rubber cushion (option)