Filter
Top Products
4
2. Connect the other end of the small cable supplied to the motor power supply
housing (on the bottom back or side of the turntable). Connect the small male
end of the cable attached to the wall wart power supply to the female input on
back of the cruise control labeled .INPUT ~16V 1A
3. Move the belt to the larger 45rpm motor pulley position.
4. Plug the AC end of the wall wart power supply into the wall.
Turntables without and external wall wart power supply 120V motor
OUTPUT ~120V 3W
()
should be connected to the - receptacle on the cruise
control. There is no need to use the small connecting cable supplied with the
cruise control. Store this cable in a safe memorable space in case you upgrade
your turntable to a more contemporary 16V motor model.
cruise control 2.0
slower fasterstandby
33/45
OPERATION
Press the 33/45 button on the front of the cruise control to change speeds from
33.3/45rpm.
Press and hold the 33/45 button to engage which stops the motor from
spinning. Push the button again to begin the motor spinning. The selected speed
will be displayed digitally in the front display window on the cruise control.
.
standby
Please always start the turntable at 33.3 rpm and then switch to the
higher desired speed
1. Connect one end of the small cable supplied to the female receptacle on the
back of the cruise control labeled .OUTPUT ~16V 3W