Milwaukee C12-28 DCR Clock Radio User Manual


  Open as PDF
of 8
 
6
SettingtheClock
1. Press and hold the CLOCK button until the hour
begins to ash.
2. Use the buttons to change the hour.
3. Press the CLOCK button again. Use the
to change the minutes.
4. Press the CLOCK button again to save.
EQAdjustment
To manually adjust the Bass/Treble sound, press
the EQ button. Set the bass sound using the
buttons. Press the EQ button again to set the treble
sound, using the buttons.
SelectingBand
Push the MODE button to select AM, FM, or AUX.
Tuning(SeekingandScanning)
Press and hold the
buttons to SEEK through
the band. When a station is found, the SEEK will
stop. Use the SCAN button to continue through the
stations, pausing at each.
PRESETStations
Tosetthe PRESET stations:
1. Tune to desired station.
2. Press and hold the PRESET button until the
PRESET indicator on the display begins to ash.
3. Use the
buttons to select the PRESET
location for the station. Ten locations (0-9) are
available.
4. Press the PRESET button to save the location.
To tune to a PRESET station:
Press and release the PRESET button to step
through the PRESET stations.
UsingtheStereoAUXJack
1. Open the Battery/Auxiliary Compartment
2. Plug the auxiliary device into the Stereo AUX
jack.
3. Use the MODE button to select AUX.
4. Start the auxiliary device.
mainTenance
Warning Toreducetheriskofper-
sonalinjuryanddamage,neverimmerseyour
tool,batterypackorchargerinliquidorallow
aliquidtoowinsidethem.
Warning Toreducetheriskofinjury,
alwaysunplugthechargerandremovethe
batterypackfromthechargerortoolbefore
performinganymaintenance.Neverdisas-
semblethetool,batterypackorcharger.
Contact\RXUORFDODXWKRULVHG
MILWAUKEE® dealer or service centre.
MaintainingTool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
If the tool does not start or operate at full power
with a fully charged battery pack, clean the contacts
on the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
Cleaning
Clean dust and debris from charger and tool
vents. Keep tool handles clean, dry and free of oil
or grease. Use only mild soap and a damp cloth
to clean the tool, battery pack and charger since
certain cleaning agents and solvents are harmful to
plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia
and household detergents containing ammonia.
Never use flammable or combustible solvents
around tools.
Repairs
For repairs, return the tool, battery pack and char-
accessories
For a complete listing of accessories refer to your
Warning Alwaysremovebattery
packbeforechangingorremovingacces-
sories.Onlyuseaccessoriesspecifically
recommendedforthistool.Othersmaybe
hazardous.
to your local authorised 0,/:$8.((
®
dealer or
service centre
ger to your local authorised 0,/:$8.((
®
dealer or service centre for assistance.
MI/:$8KEE
Electric Tool catalogue or go
online to milwaukeetools.com.au or
milwaukeetools.co.nz
To contain a catalogue, contact your local
authorised 0,/:$8.((
®
dealer or service
centre.
 previous next