Filter
Top Products
6
LOCATION OF CONTROLS (CONTINUED)
BATTERY INSTALLATION
The remote control transmitter is designed to operate
with two (2) “AAA” size batteries (not included). To install
the batteries, slide the battery compartment cover open
on the back of the remote control and insert two (2)
“AAA” size batteries observing the polarity (see figure to
the right). Replace the battery compartment cover.
+
-
+
-
1
12
13
15
16
17
18
14
2
4
3
6
5
7
8
9
10
11
1. OPEN/CLOSE Button
2. Number Buttons
3. OVER Button
4. STOP (
■
) Button
5. PLAY/PAUSE ( ) Button
6. SKIP/TUNING Button
7. SKIP/TUNING Button
8. MEM DOWN/ RANDOM Button
9. MEM UP/REPEAT Button
10. TUNER/BAND Button
11. CD Button
12. POWER Button
13. MUTE Button
14. VOLUME +/– Buttons
15. MEM/CLOCK SET Button
16. TIMER Button
17. DISPLAY Button
18. Battery Compartment (Rear)
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old
batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer’s directions.)
BATTERY INSTALLATION
MMG-CR3810.OM.QXD 7/15/02 7:09 AM Page 6