Filter
Top Products
15
Installation, con’t
Remove
Screws
Remove
Screws
Figure 20
Note: Use extreme caution to
avoid any existing
electrical wiring,
plumbing, etc., located
inside the wall.
4. Refer to figures 23 and 24 to in-
stall the appropriate Wall Brack-
ets on the wall (orient the bracket
as illustrated) using the supplied
Mounting Screws. If the Flush
Mount Brackets are used, option-
ally attach the two cone shaped
rubber bumpers to the rear of the
Loudspeaker, near the bottom.
Note: If the wall covering
material and/or thickness
is different from the
illustration, the two
supplied Mounting Screws
need to be replaced with
screws of the appropriate
type and length.
5. Orient the Loudspeaker with the
rounded end at the Top, carefully
line up the Loudspeaker Brackets
with the Wall Brackets and lower
the Loudspeaker. If the angle
mount is used, install the Locking
Screw for
the top
Bracket to
secure the
Loud-
speaker at
the desired
angle.
6. Align the
Grille fas-
teners to the Loudspeaker Grom-
mets (three on each side). Care-
fully push down to secure the Grille
Figure 21
Figure 22
Figure 23 Figure 24