Filter
Top Products
14
Before you begin, turn on the power of your TV, stereo, and any other equipment connected to
the DVD Player. Make sure the TV and the stereo (if applicable) are set to the correct channel.
1 Slide the POWER switch to ON to turn on the player.
2 Press OPEN to open the disc tray.
3 Place a disc into the tray. If the DVD is recorded on only one side, place the disc in the tray
with the label facing up and the shiny side facing down. Some DVDs are recorded on both
sides. Make sure the label of the side you want to play is facing up.
4 Press the tray door down to close the tray.
5 To start playback, press
B
(PLAY) /OK.
- To play MP3 CDs, see page 23.
6 Adjust the volume by using the VOLUME control.
7 To stop playback, press
9
(STOP) once. Pressing
9
(STOP) twice stops resume.
8 Slide the POWER switch to OFF to turn off the player.
TIP :
During operation of the player you may hear a mechanical noise. This is normal.
Basic Operations: Playback
1
2
VOLUME
OPEN
MPD820_17.qxd 4/2/04 9:10 AM Page 14