Filter
Top Products
7 Operating Instructions
OPERATING MODES
There are two operating modes in MV-Flash M3+ – “playlist mode” and “simple play mode”
.
1. Playlist mode
When operating in playlist mode, both project file (*.prj) and playlist file (*.pll) must be
present on the Compact Flash card. These are used to control the sequence for all video
tracks.
The project and playlist file are created using DV Studio Advanced software. Using this
software, you can set simple sequences or complex sequences including “jump track“ or
“next track” actions. DV Studio can also program buttons with different function like “play”,
“stop”, “pause”, “mute”, “previous”, “next” and “volume”.
2. Simple play mode
In simple play mode, the user just copies all video files (.mpg) or JPEG files (.jpg) onto the
Compact Flash card. The MV-Flash M3+ will play these files in alphabetical sequence.
For MPEG still pictures or JPEG files, the play time can be set by the last digit of the
filename. (For example: APPLE5.mpg, where “5” means the track will be displayed for 5
seconds.) Note: Do not use the same filename on both MPEG and JPEG.
Note: Make sure all capital letters in filename defined in playlist are consistence with the
filename on CompactFlash card. All filename should be in 8+3 format (i.e. xxxxxxxx.xxx) and
avoid using any illegal characters like “~”, “_”, “-“, etc
OPERATING FUNCTIONS
The following key buttons are default in “Simple Play mode”
PLAY (Button 1)
• Resumes playback of videos from track 1 after STOP has been pressed.
• Resumes playback of the track from the point that it has been set to PAUSE.
• Playback is reset back to the beginning of the specific track which is being played at
the time the PLAY button is pressed.
STOP (Button 2)
• When STOP is pressed the video stops playing and a blank screen is displayed.
PAUSE (Button 3)
• When PAUSE is pressed the video image instantly freezes.
• Press Pause again or PLAY to resume normal playback from the position where it was
paused.
- 14 -