Filter
Top Products
5
AC adapter
receptacle
DETAILED SET-UP GUIDE
BATTERY INSTALLATION
1. Remove the battery cover.
2. Observe the correct polarity and install 2 AA batteries.
3. In addition or instead of
inserting batteries, the AC
adapter can be used. Simply
plug the adapter into the
receptacle on the bottom of
the alarm clock and then
plug in adapter.
4. Replace the battery cover.
5. The projector will activate and remain on if the alarm clock is plugged in. If
only batteries are used, the projector will only be activated when a button is
pressed. The projection is a red light, not harmful under normal usage,
although care should be taken to not look directly into the light.
Note
: After the batteries have been installed a tone will sound and the LCD
(Liquid Crystal Display) will activate. The date and U.S. map will be
displayed and the time will appear as “-:--”. The WWVB search is
automatically initiated and a tower icon appears and flashes with the time
colon (no tower icon will appear if the WWVB is too weak to be detected
and the time display will remain on “-:--”). While the WWVB search is
being conducted various numbers will appear in the time display. After 10
minutes, the Projection Alarm will either display the WWVB time, or
discontinue the search if the time is not found. If the search is cancelled “-:-
-” will remain in the time LCD. The Projection Alarm will conduct a
WWVB search every hour until the first signal is found. Once the WWVB
time is found, a search is automatically conducted nightly at midnight. If the
signal is found at midnight, the tower icon will appear. If not, another
search will take place every hour (until 6:00 am) until the signal is received
successfully. If no signal is found during this period, the tower icon will not
appear and the clock will search again at 12:00 am the next night.