Filter
Top Products
Note: When using the AC adaptor, plug into the projection alarm first and
then into the electrical outlet (this will help avoid pressing any buttons
inadvertently).
3) Wait 10 minutes for WWVB reception and remote temperature.
4) If there is no WWVB reception, manually set the time and date
(instructions in the Program Mode).
5) Program the settings.
6) Mount the WT-5442 in a suitable location, where WWVB and
transmitter signals can be received.
7) Mount the transmitter where remote temperature measurement is
desired (on the North side of a house for example).
Note: The remote transmitter is weather resistant but not waterproof.
High humidity and mist will not damage the transmitter but direct rain will.
The maximum range between the transmitter and projection alarm is 80ft.
open air (no obstructions). Any resistance (i.e. walls, furniture, etc)
between the two will decrease the effective operating range.
8) The projector will activate and remain on if the alarm clock is plugged
in. If only batteries are used, the projector will only be activated when a
button is pressed.
9) See the “Features” section III. for instructions on projection direction,
etc.
DETAILED SET-UP GUIDE
I. BATTERY INSTALLATION
A. REMOTE TEMPERATURE TRANSMITTER
1. Remove the battery cover. Observing the correct polarity,
install 2 AA batteries. The batteries will fit tightly (to avoid
start-up problems make sure that they do not spring free
during installation).
2. Replace the battery cover.
4