Filter
Top Products
TROUBLESHOOTING
Problem:
The Projection is faint
Solution:
1) Change intensity setting
2) Use AC adapter
3) Darken surroundings
4) Use fresh batteries (if AC is not used)
Problem:
The LCD is faint.
Solution:
1) Replace the batteries.
Problem:
“OFL” appears in the indoor temperature LCD.
Solution:
1) Move unit to an area with warmer or cooler
surrounding temperature. Current surrounding
temperatures are outside measuring range.
Problem:
No reception of WWVB signal.
Solution:
1) It may help reception to face the
front of the Projection alarm in the general
direction of Ft. Collins, Colorado.
2) Wait overnight for signal.
3) Be sure the Projection alarm is at
least 6 feet from any electrical devices, i.e.
TV sets, computers, or other radio controlled
clocks.
4) Remove batteries for five minutes,
reinsert and leave the unit alone overnight
without pressing buttons.
5) If problems persist contact La
Crosse Technology.
Problem:
Hour is incorrect (minute and date are correct).
Solution:
1) Be sure correct time zone and daylight
saving time is selected.
Problem:
“--.-” appears in outdoor temperature LCD
Solution:
1) Check batteries in remote
2) If batteries are replaced in remote, the unit
must be re-started. Remove all batteries, and
then follow start up procedure.
Problem:
“OFL” appears in the outdoor temperature LCD
Solution:
1) Remote temperature is out of range.
2) Check batteries.
3) Interference from an outside source
(cordless telephone, etc.)
4) Contact La Crosse Technology.
Note:
For any questions not answered, contact La Crosse Technology with the
contact information found at the end of this instructional manual.
15