Filter
Top Products
21
8. Fit the mounting post (on the back of the remote thermo/hygro sensor)
into the receptor of the mounting bracket.
B. Mounting With Adhesive Tape
1. With a nonabrasive solution, clean and dry the back of the mounting
bracket and the mounting surface to ensure a secure hold. The
mounting surface should be smooth and flat.
2. Remove the protective strip from one side of the tape. Press firmly
onto the designated area on the back of the mounting bracket.
3. Remove the protective strip from the other side of the tape, and situate
the mounting bracket. Firmly press the mounting bracket onto the
mounting surface.
4.
Fit the mounting post into the receptor of the mounting bracket.
II. The Indoor Weather Station
A. The indoor weather station can be mounted in two ways:
• with the table stand or,
• on the wall with the use of a wall hanging screw (not included).
1. Using the Table Stand
a. The indoor weather station comes with the table stand already
mounted. If you wish to use the table-stand all that is required
is to place the indoor weather station in an appropriate
location.
2. WALL MOUNTING
a. Remove the table-stand. To do this, pull down on the stand
from the rear and rotate forward.
b. Fix a screw (not included) into the desired wall, leaving
approximately 3/16 of an inch (5mm) extended from the wall.
c. Place the indoor weather station onto the screw using the
hanging hole on the backside. Gently pull the indoor weather
station down to lock the screw into place.
TROUBLESHOOTING