Kenwood M2GD55 Clock Radio User Manual


 
English31
Notes on Disposal
Recycling the Built-in Battery
The Transmitter uses a lithium ion rechargeable battery cell as the built-in battery. The
lithium ion rechargeable battery is a recyclable resource. When disposing of the Transmitter,
take out the built-in battery and bring it to your local recycling business.
WARNING
• Do not heat excessively the built-in battery, open it, modify it or throw it in fire or
water.
Excessive heat generation, explosion or fire ignition may cause a fire.
• Do not leave the built-in battery near fire or under direct sunlight.
A fire, explosion or excessive heat generation may result.
• Attach insulating tape on the connectors of the built-in battery.
A fire or explosion may result if the battery electrodes are short-circuited.
• Do not leave the built-in battery within the reach of children.
Injury or other accidents may result.
• If the built-in battery fluid leaks and enters your eyes, immediately rinse your eyes
with fresh water and call a doctor.
If the fluid is left in your eyes, an eye injury may result.
Removing the Rechargeable Battery (Built-in Battery) Before Disposal:
M2GD55
IMPORTANT:
Never attempt to open the Player besides when disposing of it.
For replacement of the built-in battery, contact your nearest Kenwood service agent.
• Remove the built-in battery after having confirmed that it is completely discharged.
• Once the built-in battery is disconnected, do not attempt to reconnect it to the connector on
the circuit board.
• Bring the removed built-in battery to a rechargeable battery recycling business as early as
possible.
1 Open the USB cover.
2 Remove the 2 screws from the panel
using a precision Phillips screwdriver
(+).
3 Remove the back panel (by releasing
7 latches).
4 Disconnect the built-in battery from the
connector. Be careful not to apply an
excessive force on the connector.
5 Take out the built-in battery. Be careful
not to injure your nail or finger during
removal.
6 Attach a piece of insulating tape on
the connector at the end of the cable
from the built-in battery, and put it in a
plastic bag, etc.
Appendix