Filter
Top Products
E - 13
PLAYING A DISC
This owner’s manual explains the basic instructions for operating this unit. Some DVDs are
produced in a manner that allows specific or limited operation during playback. Therefore, this
unit may not respond to all operating commands. THIS IS NOT A DEFECT. Please refer to the
instructions accompanying the specific DVD in question for more information about the options
available on that DVD.
“ ” may appear on the screen during operation. The “ ” symbol means that the desired
operation is not permitted by the unit or disc.
Basic playback
Playing a Disc
1.Slide the POWER ON/OFF switch on the left side of the unit to the ON position.
2.Push the OPEN switch to open the disc door.
3.Hold the disc by its sides and carefully place it onto the spindle with the label side facing up; press the disc down
until you hear a “click”.
4.Push the door to close.
It takes a short while for your unit to load the disc. After loading, the unit will automatically either bring you to the
main menu of the DVD, or start playing the DVD.
5.If the unit does not automatically start playing the DVD, press the
PLAY button from the main menu.
DVD
CD
Pausing playback (still mode)
Press the
II
PAUSE button. To resume normal playback, press the PLAY button.
Each time you press the
II
PAUSE button, the picture advances one frame.
Stopping playback
Press the ■ STOP button at the location where you want to interrupt playback. To resume playback at the position
where the disc was stopped, press the
PLAY button.
If you press the ■ STOP button twice, the unit’s memory will be cleared and pressing the
PLAY button will reset
the disc to the beginning.
Skipping to a different track
• Press the PREV button to skip to the start of the current track.
• Press the
NEXT button to skip to the next track.
• For audio CDs, use the number buttons on the remote control to jump immediately to the desired track number.
(continued on next page)(continued on next page)
(continued on next page)(continued on next page)
(continued on next page)
P13_v6.pmd 10/18/2005, 12:06 PM13