Filter
Top Products
2
RD-T7GN/RD-T5BU(US) / LVT0737-003A / English
English
■■
Getting Started
Check that you have all of the following items, which are supplied with the System.
Power Cord (1)
Remote Control (1) [RD-T7GN Only]
Batteries for Remote Control (2) [RD-T7GN Only]
AC Plug Adaptor (1)
If any of these items are missing, contact your dealer immediately
To avoid damaging the System, set the voltage before plugging in the System.
Set the correct voltage for your area with the VOLTAGE SELECTOR switch on the back of the Unit. Use a screwdriver to rotate the selector
so the number the arrow is pointed at is the same as the voltage.
.
How To Put Batteries In the Unit
1. Open the battery cover on the back of the Unit by pulling it toward you while pressing the tabs as shown by the arrows.
2. Put 3 memory backup batteries R6P(SUM-3)/AA(15F) in the battery compartment in the order of “1” to “3”.
3. Put 6 batteries R20/D (13F) in the battery compartment in the order of “1” to “6” as shown.
4. Securely close the battery cover.
Note:
When you operate your Unit on mains (AC) power, the power source switches automatically from batteries to AC. However, you should
remove the batteries when operating on AC power.
How To Put Batteries In the Remote Control
Match the polarity (+ and –) on the batteries with the + and – markings in the battery compartment.
CAUTION: Handle batteries properly.
To avoid battery leakage or explosion:
• Remove batteries when the Unit or the Remote Control will not be used for a long time.
• When you need to replace the batteries, replace batteries at the same time with new ones.
• Do not use an old battery with new ones.
• Do not use different types of batteries together.
• Do not try to recharge non-rechargeable batteries.
Accessories
Set the VOLTAGE SELECTOR Switch
How To Put Batteries
1
4
6
5
3
2
“R20/D (13F)” size batteries
1
3
2
“R6P (SUM-3) / AA (15F)” size batteries
R6P(SUM-3)/AA(15F)
RD-T5BU&T7GN(US).book Page 2 Friday, June 29, 2001 9:08 AM