Filter
Top Products
5
English
■■
Using the Tuner
REMOTE CONTROL RM-SRCBZ6
Number keys
TUNER BAND
4
¢
JOG dial
PRESET
TUNER BAND
Band display, Frequency display, Preset channel
Analog clock
(Display when using the Tuner)
¢
4
You can listen to FM and AM stations. Stations can be tuned in
manually, automatically, or from preset memory storage.
One Touch Radio (AC power only)—
Just press the TUNER BAND button to turn on the Unit and start
playing the station you were last tuned to.
■ You can also switch from any other sound source to the radio by
pressing the TUNER BAND button.
■
1. Press the TUNER BAND button.
The Band and Frequency you were last tuned to appear on the
display.
Each time you press the button, the band changes as follows:
■
2. Select a station using one of the following
methods.
■ Manual Tuning
Press the 4 or ¢ button repeatedly to move from frequency
to frequency until you find the station you want.
OR
■ Auto Tuning
If you press and hold the 4 or ¢ button for one second or
more, the frequency changes down, or up, automatically until a
station is found.
OR
■ Preset Tuning using the Unit (Possible only after pre-
setting stations)
Press the
7
PRESET button to select the preset station.
After you have selected the preset number, the band and the fre-
quency are displayed.
• Example:Press the
7
PRESET button until the preset
number 12 “P- 12” appears.
OR
■ Preset Tuning using the Remote Control (Possible
only after presetting stations)
Select the station by entering its preset number on the number
keys.
• Example:For channel 5, press 5. For channel 15, press +10
then 5.
• The band and the frequency are displayed.
■
3. Turn the antenna for best reception.
• For FM broadcast, extend and turn the telescopic antenna.
• For AM broadcast, turn the Unit itself.
You can preset up to 15 FM stations and up to 15 AM stations into
memory using the Remote Control.
Auto Presetting (Using the Unit) ——
In each band, you can automatically preset FM-15, AM-15 stations.
Preset numbers will be allocated as stations are found, starting from
the station currently tuned to and moving up the frequency.
■
1. Select a band (AM or FM) by pressing the
TUNER BAND button.
■
2. Press the 7 PRESET button for more than
two seconds.
■
3. Repeat steps 1-2 for the other band.
■ If you want to change any of the auto preset stations, follow the
procedure for Manual Presetting.
CAUTION: If the Unit is unplugged or if a power
failure occurs, the preset stations will be erased
after approx. five minutes. If this happens, you
will need to preset the stations again.
Tuning In a Station
FM Auto FM MONO AM
or
Presetting Stations
For FM
For AM
Rc-BZ6BU(J)-e.fm Page 5 Tuesday, February 22, 2000 4:47 PM