Filter
Top Products
6
Canceling the Display Demonstration (Demo)
When you connect the AC power cord for the first time, the display demonstration starts
automatically.
• When you operate the unit, the display demonstration stops temporarily. If no operation is done
for about 2 minutes, the unit starts the display demonstration again.
• To activate again, hold down DEMO until “DEMO ON” appears on the display.
• When ECO mode is activated (P.10), the display demonstration does not function.
Turning on the Power Automatically (Motion Sensor)
When you move your hand or an object closer to Motion sensor (P.7), the unit turns on
automatically.
• iPod starts playback or an FM broadcast is received if you selected either of them last time.
• Motion Sensor works even if ECO mode is activated.
• To deactivate, press MOTION SENSOR. “M.S OFF” appears on the display.
NOTE:
• If the AC power cord is unplugged, Motion Sensor does not work.
• Deactivate Motion Sensor in the following cases to prevent the unit from turning on automatically:
–when you do not use the unit for a long time
–when you use Timer
Button
Operation
On the unit
Hold down until “DEMO OFF” appears on the display.
Button
Operation
On the unit
Press to activate Motion Sensor. “ M.S ON” appears on the display.
• When you select Clock as the display information or the unit is on standby,
“ ” is shown on the display (see page 10).
NX-PN10[C].BOOK Page 6 Friday, May 21, 2010 11:24 AM