Filter
Top Products
4
English
When power is supplied from the batteries:
When the Unit is turned off with the POWER button on the Unit
(the POWER button on the Remote Control is ineffective), the
Standby indicator goes out and the display is blank.
To switch off the Unit completely, remove the batteries from the
Unit.
Turn the VOLUME control on the Unit to the right or left to in-
crease or decrease the volume level.
CAUTION: DO NOT turn on the Unit and/or start
playing any source without first setting the VOL-
UME control to 0, as a sudden blast of sound can
damage your hearing, speakers and/or head-
phones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.
The System has the following preset sound effects that give you
control over the way your music sounds, so you can tailor it to the
acoustics of your room and the quality of your source. Test the
sound effects out to hear how each affects the music. Note that the
effects work only during playback.
Sound effects
FLAT: No sound effect.
BEAT: Boosts low and high frequencies.
POP: Good for vocal music.
CLEAR: For a wide, dynamic stereo sound.
To get an effect, press the SOUND button repeatedly until the
Sound mode you want appears on the display.
Each time you press the SOUND button, the display changes as
shown below:
To cancel the effect, press the SOUND button until “FLAT” ap-
pears on the display
Adjusting the Volume
Sound Effects (SOUND)
FLATBEAT POP CLEAR
BASS BASS
■■
Using the Tuner
REMOTE CONTROL RM-SRCBZ5
Number keys
TUNER BAND
4
¢
4
¢
TUNER BAND
Band display, Frequency display, Preset channel
(Display when using the Tuner)
PRESET
You can listen to FM and AM stations. Stations can be tuned in
manually, automatically, or from preset memory storage.
One Touch Radio (AC power only)—
Just press the TUNER BAND button to turn on the Unit and start
playing the station you were last tuned to.
■ You can also switch from any other sound source to the radio by
pressing the TUNER BAND button.
■
1. Press the TUNER BAND button.
The Band and Frequency you were last tuned to appear on the
display.
Each time you press the button, the band changes as follows:
■
2. Select a station using one of the following
methods.
■ Manual Tuning
Press the 4 or ¢ button repeatedly to move from frequency
to frequency until you find the station you want.
OR
■ Auto Tuning
If you press and hold the
4 or ¢ button for one second or
more, the frequency changes down, or up, automatically until a
station is found.
OR
■ Preset Tuning using the Unit (Possible only after pre-
setting stations)
Press the PRESET button to select the preset station.
After you have selected the preset number, the band and the fre-
quency are displayed.
Tuning In a Station
FM Auto FM MONO AM
or
Rc-qn1(J)-e.fm Page 4 Thursday, January 13, 2000 4:32 PM