Filter
Top Products
10 JL AUDIO ZR650-CSi
TWEETER INSTALLATION:
First, run speaker wires from the tweeter output
of the crossover (see diagrams on page 5) to the
desired tweeter mounting locations, observing
the same precautions as mentioned in the woofer
installation section. Terminate the wires with the
supplied 2.8 mm male crimpable connectors.
TWEETER FIXTURE INSTALLATION:
The dome tweeters supplied with your
ZR650-CSi system have been designed for
maximum mounting versatility. There are two
primary methods by which the tweeters can be
mounted in your vehicle:
Flush-Mount: Two different styles of flush-mount
fixtures are provided: a compact, simple design and
an enhanced design. Both are installed using the
same method (shown in Diagram E), but require
different size mounting cutouts. Refer to page 2 for
cutout dimensions.
Flush-mounting yields a custom-installed
appearance, but will require at least 3/4-inch (19
mm) of clearance behind the mounting surface of
the tweeter. Install as shown in Diagram E, using
the spring clips and 1-inch machine screws (it may
be necessary in some limited depth applications to
cut down the length of the machine screw, or use
a shorter screw (not supplied). Hand-tighten the
machine screw until the fixture is secure.
Surface-Mount: In this application, you will not
need to cut large holes in your vehicle’s panels for
the tweeters. You will only need to drill a hole for
the wires and two smaller holes for the mounting
screws. This application is useful when mounting the
tweeters to a panel that has insufficient clearance
behind it for the tweeter’s magnet structure.
Using the fixture as a template, mark the screw
hole locations and a location in the center of the
fixture for the wire hole. Remove the fixture and
drill pilot holes for the screws and a 1/8-inch (3
mm) for the wires. Use the supplied #6 x 5/8-inch
sheet metal screws to secure the fixture as shown in
Diagram F (hand-tighten). Run the tweeter's wires
through the hole and insert the tweeter until it
snaps into place.