Filter
Top Products
SETTING THE ALARM TIME
1. Set the Clock Setting Switch (#5) to the “ALM” position. The 2 dots
between the hour and minutes will begin flashing.
2. Rotate the Rotary Set Dial (#8) counterclockwise or clockwise for
adjusting the hour or minute for the alarm respectively.
3. Once the alarm is adjusted to the desired wake-up time, set the
Clock Setting Switch (#5) to “RUN” position. The 2 flashing dots will
stop flashing.
4. Note: Do not rotate the dial too quickly when you are setting the
clock or alarm to insure desired time and alarm settings.
ALARM OPERATION
Set the ON/AUTO/OFF Switch (#6) to the “AUTO” position. The AUTO
Indicator (#20) will light.
- WAKE TO RADIO
Set the radio Tuning Control Knob (#10) to the station you wish to
listen to when the alarm time is reached. Set the Volume/Buzz Knob
(#12) to a desired volume level. The radio will now turn on at the
selected alarm time.
- WAKE TO BUZZER
Slide the Volume/Buzz Knob (#12) to the BUZZ position. The buzzer
will now turn on at the selected alarm time.
TIME SETTING FOCUSING FOR PROJECTION CLOCK
- To set the hours, simultaneously press and hold the Hour Button
(#16) and the Time Button (#18). Keep them depressed until the
desired hour digits are displayed.
- To preset the minutes, simultaneously press and hold the Minute
Button (#15) and the Time Button (#18). Keep them depressed until
the desired minute digits are displayed.
- Focusing: Adjust the projection clock clarity by turning the Focus
Adjustment Knob (#17) until the projected time is clearly shown on
the ceiling or wall.
Note:
1. The LED Digital Clock and the Projection Clock must be set
separately.
2. The projected time is visible on a ceiling or wall in a darkened room.
The maximum projection distance is 3-9 feet.
P6