Filter
Top Products
2-CHANNEL WIRING FOR EVEN
SOUND DISTRIBUTION
1. Use the even sound distribution connection for even sound distribution through
both channels. Run the sets of paired wires out two wire access holes
through the pole-mount bracket, as shown.
NOTE: This procedure is applicable for both large- and small-diameter
drop tubes. A large-diameter drop tube is shown here.
2-Channel-wiring for even sound distribution.
2. Remove the terminal assemblies from the rear of all speakers. The terminal
assembly is removed by rotating it slightly counterclockwise, as shown.
Use the transparent plastic strap to pull the terminal assembly out, as shown.
3. Connect the small end of the multiunit wiring adapter to the rear of speakers
A and B, as shown.
4. Place speakers A and B with connectors attached on the pole-mount bracket,
as shown. Run the wiring for the multiunit wiring adapter through the wire
access holes, as shown.
5. Slide the large end of the multiunit wiring adapter that is already attached
to speaker A into the rear of speaker C at a slight angle and rotate clockwise,
as shown.
6. Connect the terminal assembly to the back of the multiunit wiring adapter,
as shown. It will snap securely into place.
This end is connected to speaker A.
This end is connected to speaker
A.
Pole-Mount-BracketCap
DropTube
Pole-Mount
Bracket
Wire Access
Holes
Connector
Connector
Multiunit Wiring Adapter
toconnectto speaker
D
Multiunit Wiring Adapter
toconnecttospeaker
C
A
B
Pole-Mount-
Bracket Cap
Drop Tube
Pole-Mount
Bracket
Wire Access Holes
22
JBLP2605_CN_CNAW_PM-OM 4/23/08 12:57 PM Page 22