Filter
Top Products
13
4. The mounting bracket is designed to trap the flange of the JBL Control NOW
speaker by securing the mounting bracket cap with two screws through the
bottom of the mounting bracket. This will support the weight of the speaker.
Now slide the mounting-bracket cap over the assembly. Secure the mounting-
bracket cap by inserting two #10-32 x 2" screws (provided) in the bottom of the
mounting bracket and tightening. Repeat the process with the remaining speaker.
5. Now rest the second JBL Control NOW speaker’s rear flange in the mounting
bracket, as shown, and complete the process. Secure the mounting-bracket
cap with two #10-32 x 2" screws through the bottom of the mounting bracket.
6. To orient the JBL logo into the correct position, pull the JBL logo slightly
outward from the speaker grille and rotate. The JBL logo is held in place by
a spring. Peel the adhesive cover off the mounting-bracket covers and
attach to the top and bottom of the mounting assembly.
Mounting-Bracket
Covers
Mounting-Bracket
Covers
#10-32 x 2"
Screws(2)
#10-32 x 2"
Screws (2)
Mounting-Bracket Cap
MountingBracket
#10-32 x 2"Screws (2)
(side view)
(side view)
JBLP2605_CN_CNAW_PM-OM 4/23/08 12:57 PM Page 13