Filter
Top Products
5
Projection Clock Radio
www.insigniaproducts.com
Setting the sleep timer
To set the sleep timer:
1 While the radio is on, press SLEEP once. The
“SLEEP” indicator appears on the display, and
“90” appears (blinking) on the display
(indicating that the clock radio will turn off after
90 minutes).
2 Repeatedly press SLEEP to decrease the sleep
timer in 10 minute increments.
3 To cancel the sleep function, repeatedly press
SLEEP until “00” shows on the display.
Adjusting the backlight level
To adjust the backlight level:
1 Make sure the power is connected.
2 Press SNOOZE/DIMMER to set the display
backlight to a comfortable level (except when
the alarm is on). Your choices include High,
Middle, or Low.
Projecting the time
To project the time:
1 Switch off the room lights to darken the room.
2 Press PROJECT to turn the projector on.
3 Turn the projector unit slowly to aim the
projected image on the wall or ceiling.
4 If the image appears to be upside down on your
wall, or upside down on the ceiling when you
are lying in bed, press ROTATE to rotate the
projected image.
5 If the image appears fuzzy and out of focus,
slowly rotate the focus adjustment ring
clockwise or counter-clockwise until you obtain
the sharpest image.
6 To turn the projector off, press PROJECT.
Troubleshooting
Specifications
Specifications are subject to change without notice.
Note
• Do not look into the projector lens when the
time projector is on.
• The projected image of the time on your wall or
ceiling is only visible when the room lighting is
off and the room is dark. The image will not be
visible when the room lights are on.
• If you experience a power interruption when
the time projector is on, the LCD display and the
time projector turn off. When power is restored
the LCD displays to the correct time (if a backup
battery is installed), but the time projector
remains off. You must press PROJECT to switch
the time projector on again.
Caution
Do not try to repair your clock radio yourself. Doing
so will invalidate your warranty.
Problem Solution
The display is off.
Make sure that the AC-DC adapter is connected to
your clock radio and the AC-DC adapter is plugged
into a power outlet.
No sound
Increase the volume and make sure that the radio is
on and tuned to a radio station.
The sound has
interference
Make sure that the radio is not too close to a TV or
other appliance.
The LCD display is too
dim
Adjust the backlight.
Radio reception is weak
The AM bar antenna is inside the cabinet. If AM
reception is weak, change the position of the
cabinet until the internal antenna picks up the
strongest signal.The FM antenna is at the back of
the cabinet. If FM reception is weak try varying the
position and direction of the FM antenna until you
find the strongest signal.
Power supply DC IN 6V/0.5A
FM band 87.5 - 107.9 MHz in 200 KHz steps (USA)
AM band 530 - 1710 KHz in 10 KHz steps (USA)
Output power 1 W
Speaker 2.25" x 1
Operating temp. (Max) 14° ~ 104°F (-10° ~ 40°C)