Filter
Top Products
Portable DVD Player i1155_V11M11_IM_EN_10052007
www.i-Luv.com - 27 -
TROUBLESHOOTING GUIDE
No Power
•
Insert the AC power plug securely into the wall power outlet
iPod videos not displayed on the 8.4” LCD screen.
•
Check the TV settings of your iPod. The TV OUT option of your iPod must be set to ON.
Refer to the section
Watching Your iPod Videos on the 8.4” LCD Screen in this manual
for related instructions.
• Your iPod is not in the play mode. Play the video on your iPod.
iPod isn’t recharged.
•
Check whether the AC adapter is connected. In order to charge your iPod, the AC adapter
must be connected to the DVD player.
• Check whether your iPod is properly installed in the dock.
Play does not begin even after the PLAY (X) button is pressed or it starts to play and
stops immediately
•
Condensation may have formed. Allow 1 to 2 hours for the player to dry out.
• The disc may be incompatible with this unit. This player can only play DVD, VCD and CD
formats.
• The disc may be dirty and require cleaning.
• The disc may be improperly loaded. Be certain it has been loaded with the label side up.
No picture on the LCD screen
•
Ensure that the disc or iPod mode is properly set.
• Ensure that the iPod is properly connected.
No sound or distorted sound
•
Ensure that the disc or iPod mode is properly set.
• Ensure that the iPod is properly connected.
• Ensure that the input settings for the iPod are properly set.
Picture is distorted during the rapid advance or rapid reverse
•
The picture will be somewhat distorted at times. This is normal.
No rapid advance (or rapid reverse) playback
•
Some discs may have sections which prohibit the rapid advance (or rapid reverse).
Remote Control Does Not Work
•
Ensure that the batteries are installed with the correct polarities (+ and –).
• The batteries may be exhausted. Replace them with new ones.
• Point the remote control unit at the remote control sensor and attempt operation.
• Operate the remote control at a distance of less than 6m from the remote control sensor.
• Remove the obstacles between the remote control unit and remote control sensor.