Filter
Top Products
9
Playing a CD+G Disc
Programming a CD or CD+G Disc
Step 1: Press the Power Button to turn the unit on.
Step 2: Load the CD+G disc into the unit’s CD drive.
Step 3: Adjust the Source Dial to CDG.
Step 4: Press the Play/Pause Button to play the loaded disc.
Step 5: Plug in the included microphone to the Mic 1 Connection. Adjust the
On/Off Switch on the microphone to the On position.
• If feedback noise is present, move the microphone away from the unit
and/or reduce the microphone’s volume.
Step 6: Adjust the Volume Dial to adjust the volume of audio output from the
speakers. Adjust the Microphone Volume Dial to set the volume of a
connected microphone.
Step 7: Turn the AVC Select Dial to Vocal.
Step 8: Use the AVC Dial to adjust the balance between the music and vocals.
Step 9: Press the Play/Pause Button to play or pause the loaded CD+G.
Step 1: Press the Power Button to turn the unit on.
Step 2: Load the CD or CD+G into the unit’s CD drive.
Step 3: Adjust the Source Dial to CDG.
Step 4: Press the Program Button to begin programming the disc.
• The Program Indicator Light will illuminate red.
Step 5: Select a CD or CD+G track using the Skip/Search Buttons.
Step 6: Once the desired track is selected, press the Program Button.
Step 7: Repeat Step 5-6 until all of the desired tracks are programmed. (19 max)
Step 8: Press the Play/Pause Button to beging playing the programmed tracks.
IJ328-IB.indd 9 7/10/2008 2:21:42 PM