Filter
Top Products
7
Listening to iPod/iPhone
iP45 IB
Listening to FM Radio
Setting up the Antenna
Insert the FM Antenna plug into the Aux-in/FM Antenna Jack on the back of the unit. Extend the wire antenna fully for best
reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the FM Radio
1. Press the Radio/AUX Button as needed to turn iP45 on and toggle between FM radio and aux-in modes. Select FM
Radio mode. The last selected radio station will play and the frequency will appear in the display.
2. Press the or Button to tune radio to a desired station. Pressing and holding the or Button (2 sec. then
release) will seek the next clear FM radio station.
3. Press the Volume or Button to adjust the volume setting.
4. If needed, move the radio mono/stereo switch located on back of the unit to mono to improve reception/signal.
5. To turn off the unit, press the Button. iPhone/iPod will continue charging while in the dock.
Setting and using FM Presets
You can set and save up to 6 radio station presets in memory.
1. To set a station as a preset, enter radio mode. Press and hold the preset button. A number will flash indicating the preset
number being set and the accompanying frequency. Press the or Button to change the station (hold as above for
station seek). Press the preset button to confirm the station as a preset. To review your presets, press and hold the preset
button until the display flashes, then press the or Button. Press the preset Button again to exit preset mode.
1. Select and place the insert for your iPhone or iPod model. Gently insert an already playing iPhone or iPod. The iP45 will
automatically turn on and you will hear the music playing from your iPod/iPhone.
Note: If the playing song/music loudness is too low on the iPod itself, the iP45 may not detect that the iPod/iPhone is in
play mode. Press the Button to play it.
2. Press the or Button to change iPod/iPhone track forward/reverse.
3. When the iPhone/iPod is docked and in standby mode, press the Button to play it.
4. When the iPhone or iPod is in play mode, press the Button to pause play; press again to resume play.
5. Press the BonGiovi Button to activate the DPS active digital processing circuit. Press again to turn off.
6. Press the Volume or Button to adjust the iP45 volume.
7. Press the eq Button as needed to cycle through treble and bass sound settings. Press the or Button to adjust
settings for best sound.
8. To turn off the unit, press the Button. Your iPhone/iPod will continue charging while in the dock if unit is connected to
AC power. It will not charge when running on internal battery.