Filter
Top Products
8
Using the Remote auto/on Switch
Setting FM Radio Frequency/Range to Use iP45 in Other Countries
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches the
standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US, you
may skip this section.
1. Make sure the iP45 is OFF (not playing in any mode). Press and hold the Radio/AUX Button for about 5 seconds until
“USA” flashes in the lower part of the display. Press the or Button to select your region (EU=Europe, JPN= Japan,
AUS=Australia, CHN= China).
2. Press the Radio/AUX Button again (or no button within 5 seconds) to exit the radio frequency setting mode. Two beeps
will confirm the setting is complete.
The iP45 has a remote auto/on switch located on the back of the unit. Slide the switch to the AUTO position to save battery
power when traveling or operating on the internal battery. AUTO disables remote operation when operating on the internal
battery. Slide switch to ON position for normal remote operation.
iP45 IB
Using the Sleep Timer
The iP45 has an adjustable sleep timer that lets you sleep to your current sound source (iPhone, iPod or FM radio) before
shutting off after the specified time.
1. Press the sleep button as needed to cycle through the sleep time settings: 90, 60, 30, 15 minutes or OFF (cancels
sleep mode). Press the sleep button during sleep operation to review the sleep time remaining.
2. Press the Volume or Button to adjust the sleep volume. This is separate from the unit’s standard volume
setting.
3. To turn off the unit, press the Button.
Using the Aux Line-In Jack with Other Audio Devices
The iP45 has an FM antenna/aux line-in jack that lets you play other audio devices through it. Unplug FM antenna to use aux
line-in jack.
1. Plug one end of a standard 3.5mm audio patch cord (not included) into the headphone or line-out jack on your audio
device and the other end of the patch cord into the iP45 aux line-in Jack, located on the rear of the unit.
2. Press the Radio/AUX Button until “AUX-IN” appears in the display, indicating aux mode is active.
3. Turn on and play your device (device must be controlled independently of the iP45).
4. Press the Volume or Button to adjust the system volume. Adjust the output volume on your device if needed.
5. To turn off the unit, press the Button. Please remember to turn off your device, too.
Listening to FM Radio