Filter
Top Products
9
P11
Using the Unit in Other Countries
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that
matches the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA, or CHINA). The default setting is USA; if you
live in the US, you may skip this section.
1. Make sure the unit is OFF (not playing in any mode). Press and hold the + and - Button at the same time for about 5
seconds until the region flashes in the lower part of the display
and a beep sounds
. Press the + or - Buttons as needed
to set the display to your region: USA, EU (Europe), JPN (Japan), AUS (Australia), or CHN (China).
2. Press and release the + and - Button at the same time again (or no button within 10 seconds) to exit the radio frequency
setting mode. Two beeps will confirm radio frequency setting.
Listening to other portable audio devices
You can play an MP3 player or other portable audio device through the iD38 via the Line-in Jack.
1. Plug one end of an audio patch cord (available at http://
www
.ihomeaudio.com) into the headphone or line-out jack on
your device and the other end of the patch cord into the iD38 Line-in Jack, located on the back of the unit.
2. Turn on the unit and press and release the Mode Button as needed until “Aux-in” appears in the lower part of display,
indicating Aux-in playing mode.
3. Turn on and play your device.
4. Press the or Button on the unit to adjust the system volume. You may need to adjust your device volume, too.
Remember to turn off your device when you are done playing it.
Sleep Operation
Sleep mode lets you sleep to iPad/iPhone/iPod, music or the radio, gradually lowering the volume until the unit shuts off
at the selected time.
1. Press the Bedtime Button to enter sleep mode. The Sleep Icon will appear on the display to indicate sleep mode.
Sleep mode has a Gentle Sleep feature which gradually lowers the volume. The unit will automatically turn off after
the selected sleep time.
2. You can adjust the sleep timer from 120, 90, 60, 30, 15 minutes or OFF by pressing the Bedtime Button again.
3. When the display changes back to show the real time, pressing the Bedtime Button once will show the sleep time
remaining. Pressing it again will change sleep time to next lowest increment.
4. iD38 has independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the
alarm volume. Press the or Button on the iD38 to adjust the system sleep volume. The sleep volume will remain
at that level the next time you enter sleep mode until controls are changed.
5. To stop listening at any time, press the Button on the iD38 to turn it off.