Filter
Top Products
Listening to Radio
8
Listening to iPad, iPhone or iPod
1. Dock an already playing iPad, iPhone or iPod. The unit will automatically turn on and in a moment you will hear the
audio playing from your iPad/iPhone/iPod.
Note: If the audio source volume is too low on the iPad/iPhone/iPod, the unit may not detect that the iPad/iPhone/iPod
is in play mode. If so, pressing the Button on the main unit once should make it play.
2. When the iPad/iPhone/iPod is docked and in standby mode, press the Button on the unit to play the
iPad/iPhone/iPod. If the unit is already on, press and release the Mode/EQ Button as needed until “iPod” appears
on the lower part of the display, indicating the unit is in iPod mode. If your iPad, iPhone or iPod touch is in video
mode, you may see the “locked” slider on the iPad/iPhone/iPod display. If so, you will need to unlock your
iPad/iPhone/iPod.
3. Press the Button on the unit to pause play; press again to resume play.
4. Press the + or – Button on the unit to go to the next or previous track. Press and hold while track is playing for high
speed forward or reverse music search of the current track.
Adjusting Sound on the Unit
You can adjust the sound on the unit while listening to any sound source.
1. Press the or Button on the unit to adjust the system volume.
2. Press and hold the Mode/EQ Button to access EQ mode then press and release as needed to select Treble, Bass,
or Balance, then press the + or – Button to adjust settings.
TIP: You can also adjust EQ with the iHome Set app.
Listening to Radio
Setting up Antenna
Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the Radio
1. Press and release the Power Button to turn on the unit, then press and release the Mode Button as needed to cycle
through iPod, FM radio, and Aux-in modes.
2. When the desired FM mode is selected, press the + or – Button to tune the radio to a desired station. The current radio
frequency appears in the bottom of the display. Press the + or – Button for a few seconds to scan for the next clear
station.
3. To memorize a station as a preset:
A. Press the Button as needed to step through the 6 presets (P1 - P6) to the number you wish to assign, and then
hold the Button until the selected preset number begins flashing in the display.
B. Press the + or – Button to tune the radio to a desired station. Hold briefly to have the radio autoscan/search for the
next clear station.
C. Press the Button to confirm the setting, two confirmation beeps will confirm the setting and the preset number
you wish to assign. Repeat steps A-C to preset up to 6 stations.
4. To listen to a preset station, use the Mode Button to select FM mode, then press the Button to choose the desired
preset.
5. Press the or Button on the unit to adjust the system volume.
P10