Filter
Top Products
Getting Started (Initial Setup)
27
Adding Channels
Occasionally the auto-programming may skip an active channel because the antenna
was pointed in the wrong direction or the channel had a weak signal or was "off the air"
at the time of programming. Or you may change your mind about a channel you
removed from memory.
To Add or Erase Channels
• Press GUIDE twice, then press 1 to bring up the Initial Setup screen. Item 3 lets you
add or delete channels. Use the number buttons to enter the channel you want to
change, then press STOP to delete it or press PLAY to add it.
Caution After a Power Failure
If a power failure lasting for more than 5 seconds occurs, reset the clock and perform the
"AUTO CHANNEL SETTING" found in the "INITIAL SET-UP" menu.