Filter
Top Products
To Host
9
• SCSI IDs are set at the factory. Use the GUI touch
screen to change any of the factory defaults.
• To connect a library to a host, the host must have at
least one Wide LVD/SE controller and the appropriate
driver software.
• For best performance, do not attach more than two
drives per bus. A maximum of one tape drive per bus
is recommended for Ultrium 460 and 960 tape drives.
• HP recommends that the robot and drive 0
be attached to host bus 0.
• For Windows servers, power on the library before
powering on the server.
Power On the Library
10
Connect each power cord and turn on the
master power switch for each power supply.
If necessary, turn the library on by touching
the GUI touch screen.
11
12
Note: For
4-drive libraries,
the left power receptacle goes with the
bottom power supply and the right power
receptacle goes with the top power supply.
Getting Help
• HP product information:
ht
tp://www.hp.com/go/storage
• HP technical support and phone numbers:
ht
tp://www.hp.com/support
• HP StorageWorks Library and Tape Tools
(L&TT) diagnostic software:
ht
tp://www.hp.com/support/tapetools
After you install and configure the library,
complete the following setup tasks. Refer to the
HP StorageWorks MSL6000 Series Tape Library
User Guide for more information.
• Set the mailslot (optional). The default is
mailslot enabled.
• Set the SCSI IDs (if needed to avoid conflicts).
• Set the library's IP address for Web access
(optional).
• Change the default passwords (optional).
• Load tapes into the library.
• Configure your application software.