Filter
Top Products
3
English
InSTALLATIOn
INSTALLING
With only a single cable connection, The Bridge II is
easy to connect to your Harman Kardon product.
Step One: Turn off the Harman Kardon The Bridge-
or The Bridge II-ready product, using its master power
switch.
Step Two:
-Ready Products – Holding the
cable with the wider part of the connector at the
bottom, gently squeeze the tabs on each side as
you insert it into the connector on the rear panel of
the Harman Kardon product. See Figure 1.
Figure 1 – The Bridge II connector on The Bridge II-ready
Harman Kardon products
-Ready Products – A different con-
nector was used on The Bridge-ready Harman Kardon
products and the HK3490, as shown in Figure 2. Do
not plug The Bridge II directly into the DMP/The Bridge
connector on the rear panel of these products. First,
connect the included adapter to The Bridge II cable,
then plug the adapter into the product.
Figure 2 – The DMP/The Bridge connector on The Bridge-ready
Harman Kardon products
Step Three: Place the black insert in The Bridge II,
making sure to push it all the way down. See Figure 3.
NOTE: Do not place an iPod in The Bridge II unless
both the black insert and a dock adapter are installed.
Otherwise, the iPod will not connect properly, and
both it and the Bridge II may sustain damage that
is not covered by the warranty.
Step Five
Step Four
Step Three
Step Four: Locate the dock adapter that was
included with your iPod, or select one of the included
clear dock adapters by referring to Table 1. If your iPod
is an older model that does not appear in Table 1 and
that did not include an adapter, contact Apple Inc. to
purchase one.
Place the adapter in The Bridge II insert, as shown
in Figure 3.
Step Five: Remove the iPod from any case, and
dock it in The Bridge II, as shown in Figure 3.
The Bridge II Insert iPod Model
NANO iPod nano, 1st and 2nd generation
5G (VIDEO 60GB) iPod, 5th generation (60GB, 80GB) and iPod classic (160GB)
5G (VIDEO 30GB) iPod, 5th generation (30GB) and iPod classic (80GB)
13 iPod nano, 3rd generation
12, 14 iPod touch – install large bumper
Table 1 – Select the Correct The Bridge II Insert
Figure 3 –
Docking an iPod
in The Bridge II
0057CSK - HK Bridge II All v10.indd 3 10/02/09 10:32:16