Filter
Top Products
23
Scan operation is controlled by this key
sequence (i.e.
followed by
/SCAN). Display
will read “SCAN ON” or “SCAN OFF”. (Note: Scan
must be off to add/delete groups).
9/SCAN ADD/DELETE
Note: scan must be turned off before editing
the scan list. To edit the scan list, press
followed by
. The upper display line will show
“SCAN A/D”. Press
again. The display should
change to the current group name. Press
to
ramp up to the group to be changed. Then press
to ramp through the scan options. For a trunked
system, these options are “not in scan” and “in scan”.
The scan state replaces the first two letters of the
group name. The complete group name means the
group is “not in scan”. A display line beginning with
“S” means the group is “in scan”. To exit, press the
key.
0/SP
Entering
followed by
/SPC accesses
the Special Call List. This list is a programmable set
of call numbers that the user can invoke by scrolling
to the desired call number in the alpha-numeric
display and then depressing the PTT. Scrolling
forward through this list is done by pressing
/GROUP. Scrolling backward through this list is
done by pressing
followed by
/GROUP.
(See Special PC programming functions in TQ-3373,
for programming of the Special Call List.) Terminate
Special Call List access by pressing
.
Pause
A pause is entered into a stream of DTMF
numbers being dialed via the keypad. The operator
enters
or
.
The length of pause is PC
programmable.
PROGRAMMABLE OPTIONS
Call Time
-outs
The Allegra Duplex Portable provides several
time-out options to accommodate user needs. They
are summarized below:
Carrier Control Timer (CCT)
This timer is provided to limit continuous
transmit time (when not in a duplex
mode of operation). A single value can
be selected that applies to all trunked
operation.
Voice Scan Lockout Timer