Filter
Top Products
17
OPERATION
GENERAL
Turning The Radio ON/OFF
The radio is powered
ON
by pressing and
holding the button. All status indicators turn
on momentarily and after 2 seconds a short beep
will be heard and a message “---ON---” will be
displayed on the LCD. A self diagnostic test is
performed when the radio is first turned on if
enabled through programming. To turn the radio
OFF
press and hold the
button again. After
2 seconds a short beep will be heard and a
message “TURN OFF” will be displayed on the
LCD. When turned off, the radio retains the last
user selections (unless programmed for a
particular power up option).
Additionally, the
key is used to
terminate interconnect and individual calls.
Volume Adjust
The user can adjust the volume at any time
using the
and buttons. If the volume is
adjusted while a call is in progress, no audible
beeps are heard. If no call is in progress, a short
beep is heard, in addition to the visual indication, if
enabled. Additionally, the user selected “off-hook”
volume level is saved separately from the user
selected “on-hook” volume level.
EDACS OPERATION
System Selection-Ramping Names
The operator can ramp through the
programmed system names list by pressing and
releasing the
key.
If the radio is programmed for a non-split
display then the selected talk group is displayed
when the radio is idling. The first time the
key is pressed the radio displays the selected
system name. This name remains on the display