Filter
Top Products
26
2.) Select the correct adapter for your particular iPod
®
model from among the 5 different adapters included.
Each adapter is engraved with the name and/or size
of an iPod
®
model. Place the selected adapter in the
docking area so that the iPod
®
30-pin connector
passes through the opening in the adapter.
Gently press downward on the adapter until it “clicks”
and locks in place.
3.) Mount the iPod
®
Support Bracket on the docking station as shown.
This bracket provides support and prevents your iPod
®
from moving too far
backward when you operate the iPod
®
controls.
CAUTION: You must use this support bracket with all iPod
®
models to
prevent possible damage to the iPod
®
connector.
IMPORTANT iPod
®
nano INSTRUCTIONS!
If you are using this system with an iPod
®
nano you will notice that the iPod
®
30-pin connector on this unit is not properly aligned with the opening in the
iPod
®
nano adapter.
Before inserting the iPod
®
nano adapter into the docking
area you must slide the iPod
®
30-pin connector to the
left position, and then place the nano adapter into the
docking area.
NOTE: After removing the nano adapter remember
to slide the 30-pin connector back to the right
position before attempting to install any other iPod
®
adapter.
iC200_052906.p65 29/5/2006, 10:2926