Filter
Top Products
23
PLAYING CASSETTE TAPES
1.) Press the FUNCTION button to select TAPE
mode. The display shows correct time and the
TAPE indicator appears.
2.) Open the cassette door by pressing the Stop/Eject key..
3.) Place a pre-recorded cassette tape into the slots on the inside of the door with
the exposed tape facing up and the full reel on the right side. Close the cassette
door.
4.) Press the cassette Play key to begin playback.
5.) Adjust the VOLUME, EQ and DBBS controls as desired.
6.) To advance the tape rapidly press the F. Fwd key. When you reach the
desired point press the Stop/Eject key..
7.) To rewind the tape rapidly press the Rewind key. When you reach the
desired point press the Stop/Eject key..
8.) When the tape ends the Automatic Stop System releases the Play key and
shuts off the tape motor. You may then open the cassette door, remove your
tape, turn it over and play the other side if desired.
9.) When you are finished listening press the Stop/Eject key to stop the tape,
open the door, remove the tape and close the door. If you are playing a tape
and then change to the RADIO or CD function be sure to press the Stop/Eject
key to disengage the tape mechanism. This prevents excess wear andnd
tear on the mechanism.
IMPORTANT:
Always press the Stop/Eject key to shut off the tape motor before opening the
cassette door to remove your tape. The Automatic Stop System does not function
in the F. Fwd and Rewind modes. When the tape ends in the F. Fwd andnd
Rewind modes the motor continues to run. You must press the Stop/Eject
key to shut off the motor before opening the door to remove your tape.
PD5802_ib031803.p65 18/3/2003, 11:0623