Filter
Top Products
15
Listening To The Radio
1.) Press the POWER button to turn the power
‘On’. The display back lighting comes on and the
display appears as:
Press the BAND button to switch the radio
between FM and AM bands if necessary.
When listening to the FM band, raise the
telescoping FM rod antenna and extend it to its
full length.
2.) Tune to the desired station as follows:
• Automatic Tuning
Depress and hold the TUNING + / – buttons until the display begins to move,
then release the buttons. The display will move up or down and stop on the
next strong station. Repeat this procedure until the display stops on the
frequency of your desired station.
If it is an FM Stereo station the ((ST)) indicator
will appear in the display.
• Manual Tuning
Repeatedly press the TUNING + / – buttons to manually move the display up
or down to the exact frequency of your desired station.
NOTE: Use the Manual Tuning method to tune to weaker stations that
might be bypassed by the Automatic Tuning method.
3.) Press the VOLUME + / – buttons to adjust the
Volume to the desired level.
The Volume Level indicator appears in the display
as you adjust the volume level. The adjustment
range is from “V 01” to “V 30”.
iP105_052207.p65 22/5/2007, 11:3715