Filter
Top Products
35
RESETTING THE CLOCK AFTER A TOTAL MEMORY LOSS
If you do not change the built in lithium battery within a reasonable period of time
after you see the ‘flashing’ BATTERY LOW warning indicator, the lithium battery
may become exhausted and will no longer be able to supply back up power to the
SmartSet
®
internal computer. If the unit is disconnected from the AC outlet after
the battery is exhausted, or if a power interruption occurs, the SmartSet
®
memory
will be lost and the clock will need to be reset when the power is restored. Be sure
to install a fresh lithium battery before you reset the clock, otherwise the clock will
need to be reset each time the power is interrupted.
If the lithium battery is exhausted and you experience an interruption in the AC
power supply, the clock will reset itself to its initial default setting when the power is
restored.
The initial default setting is “12:00 AM, Saturday, January 1
st
(1 1), 2005”.
If you notice that the time on your SmartSet
®
clock radio is completely incorrect,
and the day indicator is also wrong, press the MONTH/DATE button to see the
date. If the date display is showing “1 1” (January 1
st
), you probably experienced
a total memory loss.
To reset the clock after a total memory loss, proceed as follows:
1.) Follow the instructions on pages 33, 34 and install a new CR2430 lithium battery
in the battery compartment.
2.) Connect the radio to your AC outlet and let the clock set itself.
3.) Depress the MONTH/DATE and TIME buttons together. The display will change
from ‘time’ to ‘year’.
While holding the MONTH/DATE and TIME buttons, press the SET + button
to set the display to the correct year, then release the buttons.
4.) Depress the MONTH/DATE button. The display will change from ‘time’ to
‘month/date’ (mm/dd).
While holding the MONTH/DATE button, press the SET + button to set the
display to the correct month and date. The Day indicator will change
automatically as you adjust the month/date settings. When the correct month
and date appear on the display, release the buttons.
CKT9100_090606.p65 6/9/2006, 11:0035