Filter
Top Products
4
PREPARATION FOR USE
UNPACKING AND SETUP
• Carefully remove the main unit and the accessories from the display
carton. Remove all the packing material from the unit and verify that
you have the following items: Main unit, external AM antenna, and
remote control (for model CKD2330 only).
• Carefully remove any small strips of tape that may have been used to
prevent the Power Panel from moving in transit.
• Unwind the AC power cord and extend it to its full length.
• Unwind the lead wire FM antenna and extend it to its full length.
• This unit was shipped with a dummy CD transit card in the CD player.
This dummy CD prevents the laser pick up from moving during
shipment. This card must be removed before you can insert your own
CDs. However in order to remove the card the unit must be connected
to the AC outlet and the Power Panel must be opened electronically.
Please refer to the instructions on page 18 of this manual.
TO AVOID DAMAGING YOUR UNIT DO NOT ATTEMPT TO
MANUALLY OPEN THE POWER PANEL.
• Place the unit on a flat, level surface such as a table, desk, counter,
shelf, etc, convenient to a 120V 60 Hz AC outlet, out of direct sunlight,
and away from sources of excess heat, dust, moisture, or strong magnetic
fields.
CKD2328_2330_B091103.p65 11/9/2003, 14:514