Filter
Top Products
DX-IPDR3
15
Maintaining
Replacing the remote control battery
To replace the battery:
1 Release the battery by inserting the tip of a pen or similar tool
into the small hole at the top right of the battery compartment.
2 Push the pen /tool into the mechanism, then slide it toward left
and hold it.
3 Pull the battery compartment out from the bottom.
4 Take out the used battery and replace it with a new one.
5 Push the battery compartment back into the remote control.
Troubleshooting
No video/ audio/ image
on TV
• Make sure that your iPod/iPhone is on the compatible list in
the Specifications on page 11.
• Make sure that your video cable is connected firmly and
correctly between the TV and your iPod dock
• Make sure that your monitor is turned on and the video
channel is correct
• Make sure that the video format is correct - NTSC / PAL
No audio with speakers • Make sure the AV cable is connected firmly and correctly
The remote control isn't
working
• Make sure you pulled the plastic tab if this is a first use
• The battery could be dead, replace it
• Make sure you are aiming at the remote sensor on the front
of the dock
DX-IPDR3_11-1053_Man_V3_EN.fm Page 15 Thursday, September 22, 2011 8:50 AM