Filter
Top Products
6
© 2003 Directed Electronics, Inc
FIGURE 1—WOOFER INSTALLATION
OPTIONAL 6x9
DRW-397
cut it to the proper size. If the hole is
oversize, it is recommended that a
spacer be built to compensate.
4. Pre-drill the holes for the mounting
screws using a 1/8" drill bit.
5. Route the supplied wires through
the speaker location to the stereo
cramp.
6. Install the screw speed clips if not
installing into a metal panel.
7. Connect the speaker wire to the
woofer taking care to observe proper
speaker polarity. Connect the pigtail
harness of the tweeter to the
matching harness of the inline
crossover.
8. Place the woofer into the hole and
attach using the supplied screws.
Take care at this time not to slip
with a tool while mounting or the
speaker could be damaged.
9. If using the optional 6x9 adapter
ring and grill, place several pieces of
the butyl compound on the edge of
the speaker grill, then press the grill
into the speaker-mounting flange.
NNOOTTEE::
A supply of butyl compound is included and can
be used to attach the speaker grill as well as
prevent rattles.