Filter
Top Products
REVLVL (Reverb Level) - The LFO controls the Reverbs Mix Level.
VOLPRE (Volume Pre) - The LFO controls the Volume after the Amp Modeling but before
the Effects.
VOLPST (Volume Post) - The LFO controls the Volume at the end of the Effects chain.
4. Rotate the Number 3 Knob to select the minimum value the assigned parameter will
reach at the bottom turn around point for the LFO (not available when volume is the
assigned parameter).
5. Rotate the Number 4 Knob to select the maximum value the assigned parameter will
reach at the top turn around point for the LFO (not available when volume is the assigned
parameter).
6. Rotate the Number 5 Knob to select the speed at which the LFO will oscillate from the
minimum to the maximum value.
7. Store your LFO assignment to your Preset. See page 9 for more information on the storing
procedure.
Factory Reset
This function resets the RP300A to its original factory settings. This procedure will erase all
custom user Presets, and recalibrate the Expression Pedal.
ATTENTION: Performing this function will erase all user-programmed data. All such
data will be lost forever! Be sure you want to erase the memory and start
fresh before continuing with this procedure.
The procedure for performing a Factory Reset is as follows:
1. Disconnect the power supply from the RP300A.
2. Press and hold the Select button while re-connecting the power to the RP300A.
3. When the display shows RST ?,release the Select button and press the Store button.
The display will read RESET indicating that the RP300A has reset the original factory set-
tings. At this point, the RP300A will automatically advance to the Expression Pedal calibra-
tion menu. Follow steps 4 through 7 of the Expression Pedal calibration section.
Expression Pedal Calibration
The Expression Pedal on the RP300A needs to be recalibrated for use after a factory reset has
been performed. This calibration procedure is automatically entered after a factory reset pro-
cedure. In the event the Pedal’s calibration fails, or if the Pedal does not function properly, it
can be re-calibrated using the Pedal Calibration procedure. This will not erase the User
Presets. The procedure for Calibrating the Expression Pedal is as follows:
1. Disconnect the PS0913B power supply from the power jack on the RP300A.
2. Press and hold the Down Footswitch while re-connecting the power.
3. Continue to hold the Down Footswitch until the Display briefly reads CALIB (calibra-
tion).
4. When the Display reads TOE DN,rock the Expression Pedal forward to the toe down
position.
5. Press any Footswitch and the Display now shows TOE UP.
6. Rock the Expression Pedal back to the toe up position.
7. Press any Footswitch. The RP300A will then enter the V-Switch Sensitivity adjustment
menu and the Display will read VSWTCH.
8. If you do not wish to adjust the V-Switch sensitivity, press any Footswitch and the RP300A
will return to Performance Mode and the Expression Pedal is now calibrated.
Note: If the Display shows ERROR, an error has occurred and steps 4 through 8
should be repeated.
20