Filter
Top Products
Platform Guide 1-5
2600 PCI bus 1: PCI slot 1 is 32-bit,
33 MHz
PCI bus 2: PCI slots 6 and 7 are
64-bit, 133 MHz
PCI bus 4: PCI slots 2 through 5
are 64-bit, 100 MHz
For dual HBA
configurations, Dell
recommends installing
the HBAs on separate
PCI buses to balance the
load on the system.
N/A An integrated
RAID controller is
installed on the
system board.
NOTE: To activate
the integrated
RAID controller,
you must install a
RAID battery
and key.
2650 PCI/PCI-X bus 1: PCI slot 1 is
64-bit, 33–100 MHz
PCI/PCI-X bus 1: PCI slot 2 is
64-bit, 33–133 MHz
PCI/PCI-X bus 2: PCI slot 3 is
64-bit, 33–133 MHz
NOTE: PCI/PCI-X slot 1 must
be empty for PCI/PCI-X slot 2 to
attain an operating speed of
133 MHz.
For dual HBA
configurations, Dell
recommends installing
the HBAs on separate
PCI buses to balance the
load on the system.
N/A An integrated
RAID controller is
installed on the
system board.
NOTE: To activate
the integrated
RAID controller,
you must install a
RAID battery
and key.
4400 PCI bus 0: PCI slots 1 and 2 are
64-bit, 33/66-MHz
PCI bus 1: PCI slots 3 through 6
are 64-bit, 33-MHz
PCI bus 2: PCI slot 7 is 32-bit,
33-MHz
For dual HBA
configurations, Dell
recommends installing
the HBAs on separate
PCI buses (PCI buses 0
and 1) to balance the
load on the system.
Install the new or
existing DRAC II in
PCI slot 7.
N/A
4600 PCI bus 0: PCI slot 1 is 32-bit,
33 MHz
PCI/PCI-X bus 1: PCI slots 2
and 3 are 64-bit, 66–100 MHz
PCI/PCI-X bus 2: PCI slots 4
and 5 are 64-bit, 66–100 MHz
PCI/PCI-X bus 3: PCI slots 6
and 7 are 64-bit, 66–100 MHz
For dual HBA
configurations, Dell
recommends installing
the HBAs on separate
PCI buses to balance the
load on the system.
Install the new or
existing DRAC III in
slot 1.
An integrated
RAID controller is
installed on the
system board.
NOTE: To activate
the integrated
RAID controller,
you must install a
RAID battery
and key.
Table 1-3. PCI Slot Assignments for PowerEdge Cluster Nodes (continued)
PowerEdge
System
PCI Buses HBA DRAC II or III RAID Controller