Filter
Top Products
Connecting to a TV
GOOD
SETTING UP YOUR PLAYER
Step 1:connect the audio cables to AUDIO OUT of the
DVD player.
Step 2:connect the yellow cable to the VIDEO on the
side of your player.
(For TVs that support S-Video Output please follow the
diagram “BETTER” bellow.)
• When connected to a TV, you can use the P/N button on
the remote to switch TV mode PAL/NTSC according to that
of your connected TV.
12
11
Quick Starting Guide
1. Open the player by raising the screen.
2. Remove the protective plastic tab
from the disc compartment.
Recommend to load it again to cover the
laser mechanism when not use for long
time.
3. Press OPEN/CLOSE on the left to
open the compartment door.
4. Place a DVD disc (label side facing
up).
Align the center of the DVD disc with the
center of the disc guide. Press gently down on the DVD to snap
the disc into place, then close the door.
5. To switch on the unit, press the POWER button.
6. Press to start playback.
In general, the DVD already inserted into the player will start
reading automatically when power is turned on.
In general, the player will immediately
start rendering the DVD program.
7. If it pops up a playback menu, press
to select a title and then press
ENTER to confirm.
When you want to stop, press , it will
return to the power-on logo. To power off
the unit, press POWER.
The DVD player will automatically power off in three minutes
after entering screen saver mode. To reset the unit, press
POWER again.
I/P
L
C
D M
O
D
E
ENTE
R
Z
OOM
SCREEN
MODE
S
ET
UP
MEN
U
P
O
WE
R
OPEN/CLOSE
/
GETTING STARTED
I/P
L
C
D M
O
D
E
ENTE
R
Z
OOM
SCREEN
MODE
S
ET
UP
MEN
U
P
O
WE
R
OPEN/CLOSE
/
TV Audio Input
Red
White
TV Video Input
Yellow