Filter
Top Products
Using Your SoundWorks 500DAB 3-2
Scanning stations in
DAB mode
There are three ways to scan for stations:
• Automatic full scan
• Quick scan
• Manual scan
Automatic full scan To do an automatic full scan
1. Press and hold the AUTOTUNE button to begin automatic scanning of all ensembles* in
Band III (see “Glossary” on page A-1). This may take a few minutes, during which you will
see the displays in the sequence below. When a station is detected, it plays immediately.
2. To preview another station, turn the TUNING knob until the name of another station
appears.
3. Press the TUNING knob to select and listen to the new station.
• * A group of stations being broadcasted on the same frequency or channel is called an ensemble.
• ** The empty block indicates the minimum required level for reception and the filled blocks indicate
current signal strength. For more information on the display shown, see “Viewing additional
information (INFO display)” on page 3-6.
When scanning stations for the
first time, opt for the automatic
full scan.
• LCD displays may vary from
region to region.
• Extend or adjust the antenna,
or relocate the radio, to find
the best reception.
Figure 3-4
**
Nemo UG.book Page 2 Monday, April 25, 2005 10:05 AM