Filter
Top Products
Using Your SoundWorks 500DAB 3-8
Adjusting the FM
tuning step
To scan your FM stations using a different tuning step, follow the steps below:
1. Make sure you are in FM mode (see above).
2. Press and hold the INFO button until you see a display similar to Figure 3-16.
3. Press the INFO button twice. A display similar to Figure 3-17 appears.
4. Press the TUNING knob to select the tuning step you want: 50 or 100 kHz.
5. To exit this display, press the INFO button.
Scanning stations in
FM mode
To switch radio modes, see “Selecting DAB mode” on page 3-1. You can scan for FM stations
manually, or use the automatic scanning (autotune) method below.
Autotune To do an autoscan
Press the AUTOTUNE button to scan for FM stations in ascending frequency.
To scan in descending frequency, press and hold the AUTOTUNE button.
Automatic scanning for an FM station begins. Once a station is successfully scanned, a
display similar to Figure 3-18 appears, and you hear the FM station’s broadcast.
Figure 3-16
Figure 3-17
Figure 3-18
Nemo UG.book Page 8 Monday, April 25, 2005 10:05 AM