Filter
Top Products
- 7 -
Power Sources
AC Power
Before connecting the unit to an AC outlet, make sure that the operating voltage of the unit has
been properly set to match the voltage of your local power supply (110V or 220V). The voltage
switch can be found on the bottom of the unit.
When you have conrmed that the proper voltage has been set, use the supplied AC power cord
to connect the unit to an AC outlet.
DC Power (Battery Operation)
Remove the battery compartment cover on the rear of the unit and insert 8 “C” batteries. Make
sure that the polarity of the batteries (+/-) match the markings on the inside of the battery compart-
ment. Replace the battery compartment cover.
Stereo Headphone Jack
Make sure to lower the volume on the unit prior to use with headphones to avoid damage to your
hearing or the headphones.
For private listening, connect a pair of headphones to the headphone jack on the unit. The speak-
ers on the unit will be disconnected during headphone use.
Power On / Function Modes
Use the Function switch to change the operation mode of the unit. Set the switch to “CD/MP3/
USB” to play CDs, MP3/WMA-CDs, or USB devices; set the switch to “Radio” to listen to the
radio (Radio mode); and set the switch to “Off” to turn off the unit.
GENERAL OPERATION
RADIO OPERATION
Set the Function switch to the RADIO position to listen to AM/FM radio broadcasts.
To listen to FM broadcasts, set the Band switch to the FM or FM ST position (FM ST = FM
Stereo). The FM Stereo indicator will light up when the tuner is receiving an FM Stereo
broadcast.
To listen to AM broadcasts, set the Band switch to the AM position.
Extend the telescopic rod antenna fully and adjust its position to obtain the best FM broad-
cast reception. The AM antenna is built into the unit; turn or move the entire unit to obtain
the best AM reception.
Turn the tuning dial to change the radio station.
•
•
•