Filter
Top Products
7
ENGLISH
Installation
Removing the unit
1. Frame
2. Insert fingers into the groove in the
front of frame and pull out to remove
the frame. (When re-attaching the
frame, point the side with the groove
downwards and attach it.)
3. Lever
Insert the levers supplied with the
unit into the grooves at both sides of
the unit as shown in figure until they
click. Pulling the levers makes it
possible to remove the unit from the
dashboard.
- DIN Rear-mount (Method B)
Installation using the screw holes on the
sides of the unit.
Fastening the unit to the factory radio
mounting bracket.
1. Select a position where the screw
holes of the bracket and the screw
holes of the main unit become
aligned, and tighten the screws at
2 places on each side. Uses truss
head machine screws (M4×6),
depending on the shape of the screw
holes in the bracket.
2. Truss head machine screw (M4×6)
3. Factory radio mounting bracket
4. Dashboard or console
5. Hook (Remove this part)
•
Note:
The mounting box, outer trim ring, and
half-sleeve are not used for method B
installation.